Holding the needle perpendicular to the stitches you just made insert it from right-to-left under the adjacent ‘V’ and pull your yarn through. (Stretching your fabric horizontally will make these loops more visible.) Step 3 Working vertically, weave your needle under every other horizontal loop of yarn that stretches between the ‘V’s created by the knit stitches. Your front and back should look like this: How to sew in vertically Step 1įrom the back of the work, take your threaded sewing needle and bring it to the front between a 'V' stitch. Repeat steps 2-3 for a few more stitches, following the path of the knitted yarn, until you feel your end is secure. Rotating your needle again, and angling it slightly to the right, insert your needle under the purl bump adjacent to the previous one you went under and continue under the purl bump from the row above that you previously came down through. Insert your needle under the purl bump adjacent to the original purl you went under and continue under the purl bump in the row below, slightly to the right. Step 2įollowing the path of the yarn in the stitched fabric, rotate your needle and bring it towards you. Insert your needle up under the nearest purl bump. How to Sew Duplicate Stitch: Wrong Side Step 1įrom the front-side of the work, take your threaded sewing needle and bring it to the back. Repeat steps 1-3 for a few more stitches or until you feel your end is secure. To create the next stitch, bring your needle to the front again at the bottom point of the adjacent 'V' stitch and repeat steps 2 and 3. Take your sewing needle through the second stitch up inserting the needle from right-to-left under the entire ‘V’ and pull your yarn through.Ĭomplete the stitch by inserting the needle in the same place where you started off and pull your yarn through. How to Sew Duplicate Stitch: Right Side Step 1įrom the back of the work, take your threaded sewing needle and bring it through to the front at the bottom point of the starting 'V' stitch. There are three versions of Duplicate Stitch in this blog post, which vary depending on the type of stitch you have worked, and the side of the work you are weaving on. Weaving in your ends using Duplicate Stitch means you will sew along the path of your yarn. Duplicate Stitchĭuplicate Stitch is an embroidery technique that follows the direction of your knitted stitch. The following techniques would be suitable for weaving in the loose ends of our Vale Scarf or Masley Cushion Cover Knitting Kits. You can always trim the excess after weaving in. This will make it easier to weave in using a sewing needle. Top Tip: Wherever you leave a tail of yarn in your project, make sure it's approximately 15cm long. These techniques can be used with any of our yarns - we'll be using The Chunky Wool to demonstrate! Of course this is not always possible, so below we’ve put together six ways to weave your ends into Stocking Stitch, Garter Stitch and Rib Stitch. That way it will be hidden, and if it pokes out, it will likely do so on the wrong side where no one can see it. Ideally, if there is a seam in your project, you should weave your ends into the seam. There are many different ways to weave in your ends, and every knitter has their favourite. To make your project neater, give it a finished look, and more comfortable to wear. To hide the ends so that they are invisible on the right or front side and don’t poke through. To make sure they are secure and prevent your project from unravelling. No matter how much we may dislike it, weaving in your yarn tails is always an inevitable step at the end of a project.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |